changing general dcm settings
The general tab allows the user to set the appropriate physical settings for the DCM.
To change the General settings:
| · | Click on the General tab located in the middle of the screen.
|
These include Base Model type, Display Type, Memory, Job History Size, etc. If a setting is grayed out the option is currently unavailable either because of setup limitations or the option has not been authorized. The memory required field is used as a guide line to let the user know approximatley how much memory the current setup will require. These figures are estimates only, and problems may occur if the memory required is greater then the memory installed on the DCM. This is only an issue with older DCMs such as the CPU5 and the CPU7 where memory is very limited.